Wolfcraft 3407 000 Instructions d'exploitation télécharger pdf (Page 25)

Nivisys, LLC Rev. 14 Aug 2014

2-5

1. Close the lens cover assembly.

2. Press the lens cover assembly onto the lens housing of the

objective lens.

3. Gently rock the lens cover assembly back and forth while

continuing to press firmly onto the lens housing.

4. The lens cover is fully seated as the rear edges of the lens

housing and lens cover assembly meet.

Figure 2-5 19mm Lens Cover Installation

2.7 35mm Lens Cover Installation:

The UTAM units are issued with the lens covers pre-installed.

In the event installation or re-installation is necessary, perform

the following procedure.

1. Close the lens cover assembly.

2. Ensure the lens cover catch is facing up.

3. Press the lens cover assembly onto the objective lens.

4. Gently rock the lens cover assembly back and forth while

continuing to press firmly onto the objective lens.

5. The lens cover is fully seated as the lens cover base and the

UTAM body meet.

LENS COVER

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 73 74

Pas de commentaire

Wolfcraft 3407 000 Instructions d'exploitation Page 25