Wolfcraft 3407 000 Instructions d'exploitation

Nivisys, LLC 15475 N. Greenway Hayden LoopSuite B-21Scottsdale, AZ 85260 USA480-970-3222 (tel)480-970-3555 (fax)[email protected]

Nivisys, LLC Rev. 14 Aug 2014viiiLIST OF FIGURESFIGURE DESCRIPTION PAGE1-1 Standard Kit Parts Illustration 1-31-2 Optio

Nivisys, LLC Rev. 14 Aug 2014ixLIST OF FIGURESFIGURE DESCRIPTION PAGE3-6 Range Focus Adjustment 100mm 3-73-3 Zoom Button

Nivisys, LLC Rev. 14 Aug 2014xThis page intentionally left blank.

Nivisys, LLC Rev. 14 Aug 20141-1CHAPTER 1:GENERAL INFORMATION1.1 Introduction:This manual provides operation and maintenance instructions for the UT

Nivisys, LLC Rev. 14 Aug 20141-2The UTAM Series objective lens is offered in a variety of focal lengths providing a choice of fields of view and targe

Nivisys, LLC Rev. 14 Aug 20141-31.4 Standard Kit Parts Illustration:The illustration below is provided for quick identification of the standard part

Nivisys, LLC Rev. 14 Aug 20141-41.5 Optional Items List:The UTAM is compatible with the following optional items and accessories listed in the follow

Nivisys, LLC Rev. 14 Aug 20141-51.6 Optional Items Illustration:The illustration is provided as a visual key to optional items that can be used with

Nivisys, LLC Rev. 14 Aug 20141-61.7 System Performance and Data:The table below lists the technical specifications and data of the UTAM system. The d

Nivisys, LLC Rev. 14 Aug 20141-7Thermal Core-16 (25µ) -32 (25µ) -32 (17µ) -64 (17µ)Sensor Resolution160 x 120 324 x 256 336 x 256 640 x 480Pixel Pit

Inside cover intentionally left blank.

Nivisys, LLC Rev. 14 Aug 20141-8Magnification and Field of View by ModelModel PN Pixel Pitch MAG FOV (H x V)PHOENIX-S 3405-000 25µ 1.3 12º x 9º

Nivisys, LLC Rev. 14 Aug 20142-1CHAPTER 2:PREPARATION FOR USE2.1 Introduction:This section contains instructions for installing and attaching variou

Nivisys, LLC Rev. 14 Aug 20142-2CAUTIONOBEY THE BATTERY MANUFACTURER’S DIRECTIONS FOR BATTERY DISPOSAL.2.3 Battery Installation:The electronic circui

Nivisys, LLC Rev. 14 Aug 20142-3end of the eyepiece lens.2. Rotate the eyecup into proper viewing position. Adjust for best fit. Figure 2-2 Eyecup I

Nivisys, LLC Rev. 14 Aug 20142-4clockwise direction. Be careful not to smudge the eyepiece lens or demist shield.2. Replace the eyecup or shuttered e

Nivisys, LLC Rev. 14 Aug 20142-51. Close the lens cover assembly.2. Press the lens cover assembly onto the lens housing of the objective lens.3. Ge

Nivisys, LLC Rev. 14 Aug 20142-6NOTEPROPER INSTALLATION OF THE LENS COVER MATCHES THE PROFILE OF THE LENS COVER BASE TO THE PROFILE OF THE UTAM BODY.

Nivisys, LLC Rev. 14 Aug 20142-7 Figure 2-7 60mm Lens Cover Installation2.9 Weapon Mount Installation (“M” and “L” Models):All UTAM can be fitted wit

Nivisys, LLC Rev. 14 Aug 20142-8NOTECORRECT ATTACHMENT OF THE WEAPON MOUNT SITUATES THE THROW LEVERS ON THE DUST COVER SIDE OF THE UTAM. Figure 2-8 H

Nivisys, LLC Rev. 14 Aug 20142-9 Figure 2-9 Slide Lock in Unlocked Position3. Rotate the throw levers to the open position. Figure 2-10 Throw

Nivisys, LLC Rev. 14 Aug 2014iOPERATOR MANUAL forUTAM SeriesUniversal Thermal Acquisition Monocular Part NUmber model deSCrIPtIoN (leNS, Core)34050

Nivisys, LLC Rev. 14 Aug 20142-10 Figure 2-11 Throw Lever Closed 6. Secure the slide lock to the locked position by pushing it forward. Figu

Nivisys, LLC Rev. 14 Aug 20142-11levers. Turning the locknut counter-clockwise makes lever positioning easier. NOTELOCKNUT REQUIRES ONLY SLIGHT MOVE

Nivisys, LLC Rev. 14 Aug 20142-12the threaded inserts in the main housing.3. Using a 3/32” hex key, fasten the double throw lever mount onto the moun

Nivisys, LLC Rev. 14 Aug 20142-132.12 Headmount Installation and Adjustment:CAUTIONDO NOT PUT ON THE HEADMOUNT WHILE THE MONOCULAR IS ATTACHED.1. Pr

Nivisys, LLC Rev. 14 Aug 20142-14 Figure 2-15 Headmount Diagram

Nivisys, LLC Rev. 14 Aug 20142-152.13 Head/Helmet Interface Installation:Install the headmount/helmet mount adapter onto the monocular by following t

Nivisys, LLC Rev. 14 Aug 20142-16 Figure 2-17 Head/Helmet Mount Interface Installation2.14 Attaching to a Head or Helmet Mount:1. Press and hold the

Nivisys, LLC Rev. 14 Aug 20142-172.15 Adjusting the Head/Helmet Interface: 1. Loosen the adjustment knob by turning it counter-clockwise. 2. For la

Nivisys, LLC Rev. 14 Aug 20142-182. Tie a knot in one end of the neck cord.3. Thread the unknotted end of the neck cord through one of the eyelets a

Nivisys, LLC Rev. 14 Aug 20142-19the connector.2. Align the mating connectors and push the remote switch into the hot shoe receptacle. 3. Tighten th

Nivisys, LLC Rev. 14 Aug 2014iiThis page intentionally left blank.

Nivisys, LLC Rev. 14 Aug 20142-20 Figure 2-21 Hook and Loop InstallationNOTEENSURE THAT THE SMOOTH SIDE FACES THE BUTTONS OF THE KEYPAD HOUSING SO

Nivisys, LLC Rev. 14 Aug 20143-1CHAPTER 3: OPERATING INSTRUCTIONS3.1 Introduction:This chapter contains instructions for the safe operation of the UTA

Nivisys, LLC Rev. 14 Aug 20143-2Figure 3-1 Controls and Indicators KEYPAD/MENU CONTROLHOTSHOEOBJECTIVELENS COVERDIOPTERADJUSTMENTRINGWEAPONMOUNTINTERF

Nivisys, LLC Rev. 14 Aug 20143-3Control andIndicatorsFunctionsKeypad/ Menu ControlSwitches unit ON or OFF.Activates Calibration, Polarity, Display Bri

Nivisys, LLC Rev. 14 Aug 20143-4NOTETHE OBJECTIVE LENS COVER MUST BE CLOSED WHILE POWERING ON TO ALLOW THE CALIBRATION OF THE SYSTEM. CALIBRATION IS

Nivisys, LLC Rev. 14 Aug 20143-5Figure 3-3 Battery Power IconsTwo conditions determine the length of time the unit will operate on a set of batteries:

Nivisys, LLC Rev. 14 Aug 20143-6A second calibration is suggested at 30 seconds after powering ON the unit. This allows the thermal sensor to adjust

Nivisys, LLC Rev. 14 Aug 20143-7 Figure 3-5 Range Focus Adjustment 60mm Figure 3-6 Range Focus Adjustment 100mm

Nivisys, LLC Rev. 14 Aug 20143-83.8 Digital Zoom: Press the Zoom button to cycle through the electronic zoom presets. Figure 3-7 Zoom Button3.9 P

Nivisys, LLC Rev. 14 Aug 20143-93.10 Display Brightness: When the system is first turned on, the unit activates white-hot with a midrange display bri

Nivisys, LLC Rev. 14 Aug 2014iiiADVISORY OVERVIEWThe following description categorizes the level of risk associated with each cautionary statement dis

Nivisys, LLC Rev. 14 Aug 20143-10 Figure 3-10 Main Menu 3.12 Selecting Display Mode: 1. Push and hold the center button until the Main Menu is disp

Nivisys, LLC Rev. 14 Aug 20143-11spots in orange and red. • MONO mode shows a Monochrome image. • COLOR 1 mode shows hot as orange and cold as purpl

Nivisys, LLC Rev. 14 Aug 20143-12 Figure 3-12 Reticle Sub-menu4. Scroll until desired reticle appears in display.5. Press the center button to sele

Nivisys, LLC Rev. 14 Aug 20143-13NOTETHE RETICLE TYPE AND POSITION WILL BE MAINTAINED THROUGH THE POWERING DOWN AND STARTING UP OF THE SYSTEM. NOTEWHE

Nivisys, LLC Rev. 14 Aug 20143-144. Adjust the reticle horizontally when the H is highlighted by using the front and rear buttons. Figure 3-15 Retic

Nivisys, LLC Rev. 14 Aug 20143-154. Power ON the UTAM Series. 5. Set the Digital Zoom at 2X.6. Select a reticle type. 7. Adjust the brightness of

Nivisys, LLC Rev. 14 Aug 20143-163.17 Determining Installed Firmware: Perform the following to determine the firmware installed on the unit:1. Push

Nivisys, LLC Rev. 14 Aug 20143-171. Push and hold the center button until the Main Menu is displayed.2. Scroll until UTILITY is highlighted3. Pres

Nivisys, LLC Rev. 14 Aug 20143-18NOTETHE INTERNAL MEMORY IS LIMITED TO APPROXIMATELY:250 IMAGES FOR THE -16 MODELS100 IMAGES FOR THE -32 MODELS50 IMAG

Nivisys, LLC Rev. 14 Aug 20143-19NOTETHE REVIEW COUNTER IN THE UPPER LEFT CORNER OF THE SCREEN SHOWS THE SPECIFIC NUMBER OF IMAGE YOU ARE VIEWING AS W

Nivisys, LLC Rev. 14 Aug 2014ivThis page intentionally left blank.

Nivisys, LLC Rev. 14 Aug 20143-20 Figure 3-19 Erase All Function 3.23 Powering OFF the UTAM Series: To power OFF the system, perform the following:1.

Nivisys, LLC Rev. 14 Aug 20143-21 Figure 3-21 Remote Switch3.25 Preparation for Storage:1. Remove batteries from the UTAM Series.2. Inspect the ba

Nivisys, LLC Rev. 14 Aug 20143-22This page intentionally left blank.

Nivisys, LLC Rev. 14 Aug 20144-1CHAPTER 4: MAINTENANCE INSTRUCTIONS 4.1 Introduction:The UTAM is designed to be used in diverse environments and rugge

Nivisys, LLC Rev. 14 Aug 20144-2with a soft clean cloth, or allow unit to air-dry before storing it.4.4 Cleaning the Optics: When cleaning of the len

Nivisys, LLC Rev. 14 Aug 20145-1CHAPTER 5: TROUBLESHOOTING5.1 Troubleshooting Procedures:Table 5-1 lists common malfunctions that may occur with the

Nivisys, LLC Rev. 14 Aug 20145-2Flickering Image on firing.Check for loose battery cap that may cause the battery to lose contact during weapon fire.T

Nivisys, LLC Rev. 14 Aug 20145-3Remote Switch keypad not working.Check to ensure hot shoe connector is completely installed into unit. Check to ensure

Nivisys, LLC Rev. 14 Aug 20145-4Will not zero.Check to see if UTAM is securely fastened to weapon mount. Check to see that weapon mount is correctly a

Nivisys, LLC Rev. 14 Aug 2014A-1APPENDIX A:SPARE AND REPAIR PARTS LISTA.1 Introduction:This section provides information needed to identify, contact a

Nivisys, LLC Rev. 14 Aug 2014vTABLE OF CONTENTSAdvisory Overview iiiTable of Contents vList of Figures viiiList of Tables ixCHAPTER 1:

Nivisys, LLC Rev. 14 Aug 2014A-2310-0024-0 Mount Adapter, V-Block 13255-000 RS-16 (Remote Switch) 11407-500 Soft Carrying Case 11407-501 Shoulder Stra

Nivisys, LLC Rev. 14 Aug 2014B-1APPENDIX B: WARRANTY INFORMATIONEquipment Warranties And Remedy: Seller warrants that each newly manufactured item sol

Nivisys, LLC Rev. 14 Aug 2014B-2B. Installation, operation or maintenance that either was not in accordance with Seller’s specifications and instruct

Nivisys, LLC Rev. 14 Aug 2014B-3Inside cover intentionally left blank.

Nivisys, LLC 15475 N. Greenway Hayden Loop, Suite 105Tempe, Arizona 85281USAnivisys.com

Nivisys, LLC Rev. 14 Aug 2014viTABLE OF CONTENTS (CONT.)CHAPTER 2: PREPARATION FOR USE (cont.) 2-12.14 Attachign to a Head/Helmet Mount 2-162.

Nivisys, LLC Rev. 14 Aug 2014viiTABLE OF CONTENTS (CONT.)CHAPTER 3: OPERATING INSTRUCTIONS 3-1 (cont.)3.21 Downloading Images 3-193.22 Erasing Imag